Q-See QT446 Manuel d'utilisateur télécharger pdf (Page 67)

ALARM OUT

Set how the alarms are handled and transmitted in this window. This controls any device

attached to the ALARM OUT port on the back of the NVR. There are three tabs; Alarm Out,

Schedule and Buzzer.

Alarm Out Tab

You can set the relay alarm out name as well as the hold time. Hold time is the interval

between consecutive alarm activations so multiple events within the interval will not cause the

alarm to sound again.

Schedule Tab

The default setting is for the ALARM OUT to be active all the time, but this can be changed

to meet your particular requirements in a similar manner to Schedule in SECTION 4.4.

Buzzer Tab

As with the Alarm Out hold time, the internal buzzer can be enabled and given a hold time.

PICTURE 7-12

1 2 ... 62 63 64 65 66 67 68 69 70 71 72 ... 75 76

Pas de commentaire

Q-See QT446 Manuel d'utilisateur Page 67