Q-See QT446 Manuel d'utilisateur télécharger pdf (Page 16)

2.4 VIDEO DISPLAY

QT-Series NVRs can use a television or a 19” or larger monitor as a main video display. Certain

models also provide the option of using a high deﬁnition display, such as an HDTV. A video

display is not needed for day to day use of your NVR if you are only monitoring it remotely

via a mobile device or using a computer, but one is needed for initial setup. It should also be

noted that, at present, it is not possible to change settings on the NVR itself using the QT

View mobile remote viewing apps and certain settings cannot be changed using the remote

monitoring software on the computer.

CONNECTING A VIDEO DISPLAY

Instructions on connecting a desired video display are included in the Quick Start Poster that

came with your system but are included here for your convenience.

VGA Monitor

Using a standard VGA monitor - the type used with most computers - with your NVR is the

preferred method and the NVR is conﬁgured with this in mind. Due to resolution restrictions,

you must use a monitor that has at least a 19” diagonal display. This information is typically

found on the back of the monitor if you are uncertain.

STEP 1. Plug a VGA cable into the port marked “VGA” on the back of the NVR.

STEP 2. Plug the other end of the VGA cable into the similar port on the back of the monitor.

STEP 3. Plug the monitor’s power cable into the surge protector.

High Definition Television

Some QT-Series NVRs include an HDMI video out port allowing you to use a high deﬁnition

television or other display that has an HDMI video input.

STEP 1. Plug an HDMI cable into the “HDMI” port on the back of the NVR.

STEP 2. Plug the other end into the “HDMI” port on the television.

STEP 3. Plug the television’s power cable into a surge protector.

PICTURE 2-4

PICTURE 2-5

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 75 76

Pas de commentaire

Q-See QT446 Manuel d'utilisateur Page 16