Q-See QCN8001D Manuel d'utilisateur télécharger pdf (Page 16)

30 31

PICTURE 2-6

PICTURE 2-7

REMOTE DEVICE

Filter

None

IP Search Manual Add

Add Cancel

2 IP Address Port Device ID Manufacturer Type

1 10.1.1.65 1 YZC2OC061966 Private IPC-HFW210

2 10.1.1.67 2 YZCAU192012 Private IPC-HFW321

2.3 ADDING AND REMOVING CAMERAS IN YOUR SYSTEM

LOCAL CAMERAS

Once you have connected your cameras, you will need to add them to your system’s

display. For cameras connecting to one of Q-See’s QC-Series NVRs, they will automatically

appear on-screen shortly after being plugged in. Cameras will be assigned to the ﬁrst

available channel by the NVR in this case, regardless of which port in the block that they

were connected to. These cameras can only be removed from your display by physically

disconnecting the cameras from the NVR.

CAMERAS ON THE SAME NETWORK

Cameras sharing the network with the NVR will not automatically connect. There are three

ways to connect them on a QC-Series NVR. The ﬁrst two methods are by either using the

Add Camera icon in the Live View window, or right-clicking within it. The third method uses

the Remote Device window located in the Main Menu.

Add Camera

Moving the cursor to the center of any empty

channel will reveal the Add Camera icon

shown in Picture 2-6. Clicking on this will

open a window listing available cameras.

Clicking on IP Search will refresh this list.

Simply click on the desired camera from the

list and it will become the camera for that

channel. Please note that it is possible to load

a camera which is already in use by another

channel. In which case, you will have two

identical channels.

PICTURE 2-8

PICTURE 2-9

QC NVR REMOTE DEVICE MENU

Use of remote IP cameras connected to a network - whether local or remote - requires

your NVR to be connected to a router. It also requires that the cameras are connected to a

router as well - even if it isn’t the same one as the NVR. If you intend to connect to devices

that are located outside of your local network, then this router must be able to access the

Internet. Instructions for connecting your system to the Internet are presented in the Remote

Monitoring Guide that also came on the CD with your system. It is also available from our

online resource at www.Q-See.com/Support.

Similarly, the remote devices must be able to communicate with the local network or Internet.

This will be covered in Section 2.4. You will need to follow the instructions in that chapter in

order to obtain an IP address for any cameras that will be accessed over the Internet. Once

you have connected your cameras to a router you can connect to them using the Remote

Device window.

This window can be reached by clicking on

the Remote Device icon in the Main menu...

MAIN MENU

SEARCH INFO SETTING

ADVANCED BACKUPREMOTE DEVICE

SHUTDOWN

...or through the Shortcut menu by right-

clicking on the screen and selecting Remote

Device.

Pan/Tilt/Zoom

Auto Focus

Color Setting

Record

Remote Device

Alarm Output

Main Menu

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 53 54

Commentaires sur ces manuels

Pas de commentaire

Q-See QCN8001D Manuel d'utilisateur Page 16

Commentaires sur ces manuels

Produits connexes et manuels pour Caméras de sécurité Q-See QCN8001D