Q-See QC8116 Manuel de service télécharger pdf (Page 13)

24 25

Border (Auto-Scan)

Use this to set the left and right end points for the camera to shift between during its Auto-Scan. The

two points can be at different elevations, but the camera will only rotate in a straight line between these

two points. If you need the camera to move to - or stop at - a third point, you should set up a Tour

(above). There can be only one Auto-Scan path.

Tour

This is also known as a “Patrol”.

1. Enter the number (1-8) for this Tour (Patrol).

2. Select the ﬁrst Preset Point by entering its

number.

3. Click Add Preset.

4. Enter additional points (up to 16) the same

way).

5. Right-click to exit this window back to the PTZ

Control window.

PICTURE 2-16

PICTURE 2-17

PICTURE 2-18

Pattern

The camera will record a pattern you create using the Directional Controls in real-time and will repeat it

exactly when you run the pattern.

1. Enter the number (1-5) for this Pattern.

2. Move your camera to where you want to start

the pattern.

3. Click Start to begin the recording. The camera

will record each stop, the time spent at each

point, the zoom, focus and other settings.

4. Click End when you have ﬁnished setting your

pattern.

1. Move your camera to either the left or right

point.

2. Click Left or Right and then move the camera

to the other point.

3. Click the other button to select the end point.

•Ifyougetyourleftandrightpoints“backwards”

the camera will move between them, but facing

the wrong way.

•WhenyouselectAuto-ScaninthePTZ Control

window, the camera will move between these

two points until stopped.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 42 43

Pas de commentaire

Q-See QC8116 Manuel de service Page 13