Q-See QC8116 Manuel de service télécharger pdf (Page 19)

36 37

3.4 SHUTDOWN

The NVR should never be shut off by unplugging

it or by using the power switch without ﬁrst using

the Shutdown function.

This function allows you to shut down the NVR

safely by letting the system ﬁnish writing ﬁles,

parking the hard drive and other actions to

preserve the electronics. Once the process has

ﬁnished (generally a minute or two), the recorder

will inform you that it can be safely unplugged or

the power switch can be turned off.

PICTURE 3-21

LOG OUT

Normally, your system will log a user out after a period of inactivity. This period can be set in the General

section of the System settings window. The Logout function allows you to secure the NVR before

then if, for example, you will be away from your system and others have access to the room where it is

located. It is also used when there are multiple users with different levels of access and control. Once

logged out, a user will need to log back in as normal.

RESTART

Your NVR is essentially a highly specialized computer. Like any other computer, its performance may

beneﬁt from being rebooted on occasion. If you have not disabled the Startup Wizard, it will launch when

the NVR restarts, but if you are not having network problems, you can exit the Wizard without having to

go through it again.

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 42 43

Pas de commentaire

Q-See QC8116 Manuel de service Page 19