Q-See QD54231Z Manuel de service télécharger pdf (Page 18)

SYSTEM INFORMATION

DISPLAY SETTING

CAMERA SETTING

FUNCTION SETTING

EXIT

After installation, please connect speed dome to power. The system goes on a self-diagnosis,

and then it pops up the above interface to show the system information.

If there is anything wrong during the self-diagnosis, system pops up error code.

The above interface disappears after speed dome received the first command (or the display

time lasts for 40 seconds.)

 ADDR: Here you can view dome address information. For example, 001-H, 1 is the address

number, -H is hard address mode. –S is software address mode.

 BAUD RATE: Dome communication baud rate.

 PARITY: Communication parity bit format.

 SOFTWARE: Dome PTZ software version.

Note:

 Please set the corresponding control information (address, baud rate and parity)

of the dome in matrix, control keyboard and DVR before using these devices to directly

control the dome.

 Please make sure all the cable connections are right.

4.1.2 Main Menu

You can open the IP dome menu via control keyboard, matrix, or speed dome control terminal.

 SYSTEM INFORMATION: Dome self-diagnosis information, address information, set north

direction, language, factory default setup, reboot and so on.

 DISPLAY INFORMATION: Display dome preset title, azimuth display, direction and etc.

 CAMERA PARAMETERS: Display dome white balance setup, exposure setup, day/night

setup, focus setup.

 FUNCTION SETTING : Set preset, pan, scan, cruise, pattern, idle motion.

 EXIT : Log out the system menu.

4.2 Menu Operation

In the speed dome main menu, you can use the left/right button on the keyboard or in the speed

dome terminal menu to configure the system menu. Before setup, please move the cursor to the

current item you want to configure.

 In main menu, please click confirm button to go to the sub menu or use left/right key to

configure setup.

 Use up/down button to select back option and then click confirm button to go back to the

previous menu.

 Use up/down button to select exit option and then click confirm button to log out system

menu.

 All setup here will not lose when encounter power failure.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 35 36

Pas de commentaire

Q-See QD54231Z Manuel de service Page 18