Q-See QSTD2408 Manuel d'utilisateur télécharger pdf (Page 36)

Digital Video Recorder User Manual

4.2.5 Alarm Configuration

Click ALARM to enter Alarm Configuration shown as Fig 4.9 Alarm

Configuration.

Fig 4.9 Alarm Configuration

Here users can set sensor type, alarm trigger and alarm hold time. The

following are the explanations of each option.

Device type: NC and NO (Normal Close and Normal Open). Set the value

according to the alarm signal type of the sensors.

Enable: Enable sensor alarm.

Trigger: Set alarm output, recording channel and speed dome linking (for PTZ

cameras). Click Set button, a window will appear shown as Fig 4.10 Alarm Out

Configuration.

Fig 4.10 Alarm Out Configuration

Alarm out: Set relay alarm out channel. You can select any alarm channels.

To record: Set recording channels. You can select any record channels. It will

record the cameras you choose here when alarm is triggered.

Buzzer: Enable buzzer on board for alarm.

To P.T.Z CH: Set linked preset and cruise for alarm if you have PTZ cameras.

You can select any channel or multiple channels as linked channels.

Alarm in holding time(s): The interval time between two consecutive sensor

alarms. If a second alarm is detected within the Hold time, it is recognized as a

continuation of the previous alarm. If a second alarm is detected after hold time,

this alarm and the previous are recognized as two different alarm events.

Alarm out holding time(s): Set relay alarm out time after alarm is triggered.

Buzzer holding time(s): Set on board buzzer time after alarm is triggered.

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 74 75

Pas de commentaire

Q-See QSTD2408 Manuel d'utilisateur Page 36