Q-See QSDT8PCRC Manuel d'utilisateur télécharger pdf (Page 36)

Error! Use the Home tab to apply

1 to the text that you want to

appear here. Error! Use the Home

tab to apply 1 to the text that

you want to appear here.

DSCP, DH-SD, Lilian, Minking, Neon, PelcoD, PelcoP, Star, VIDO, VISCA

3. Address

Communication address of P.T.Z device (ID number)

5.7.2 Serial Ports Setup

Users should first enable the P.T.Z control function of a certain camera and

select a port number in P.T.Z Protocol Setup (refer to Figure5-18), and then

set corresponding parameters in the area below:

Figure5-19 P.T.Z Serial Port Setup

1. Port

Users can set port number.

2. Baud Rate

Set P.T.Z device Baud Rate to match setting on camera, default value is 9600.

3. Data Bits

Default value is 8.

4. Parity

Odd and even parity bit, default None.

5. Stop Bits

Default value is 1.

NOTICE

Users should look

the

control board of the

P.T.Z device

and get the Baud Rate, Protocol, and Address first, then enter the

same values into the SuperDVR program.

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 103 104

Pas de commentaire

Q-See QSDT8PCRC Manuel d'utilisateur Page 36