Q-See QSD6204 Spécifications télécharger pdf (Page 12)

C. Sensor Installation

The DVR can support up to 4 sensors (not included in the DVR package) in up to four

locations.

There are two steps for sensor installation:

(a) Connect the sensor signal lines to the signal input terminal.

(b) Connect the sensor power lines to the appropriate power source.

In general, there are three different types of sensors readily available for purchase:

(1) Normal-Close (2) Normal-Open (3) Normal

[DVR-Sensor installation Diagram]

Close/Open. Below is a brief diagram on how each type of sensor is installed into the

DVR. The procedure for sensor installation is shown below:

Notice:

*After you install sensor(s), the programmed recording mode must be set to “S”

for “sensor” during the hour that you are recording (See “Chapter 5.H.Record

Schedule”).

*Contact an authorized dealer for information about buying the appropriate

sensors for your needs and for information concerning proper installation

procedures.

-9-

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 47 48

Pas de commentaire

Q-See QSD6204 Spécifications Page 12