Q-See QSIPO26X Manuel de service télécharger pdf (Page 18)

Stp2

Connect cables

Connect power cable, video cable, RS485 and network

cable with the PCB board. Close hinged door and

screw firmly. Turn on the power, the indicate light is red.

Step 3

Install dome drive

a. Before installation, please take out the

protective

foam and put it in a well place for future use.

Note: when you ship the speed dome to the

a; Pull the power cable, video

cable, RS485 and network cable

through wall mount bracket hole.

b; Loosen the screws and then

open the hinged box.

c; Pull the power cable, video

cable, RS485 and network cable

through back box feed through

hole and reserve a considerable

length.

d; Refer to the above figure, use

bolts to connect bracket and the

back box.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 64 65

Pas de commentaire

Q-See QSIPO26X Manuel de service Page 18