Q-See QSDT16PCRP Guide de l'utilisateur télécharger pdf (Page 6)

STEP 10. Click on Begin.

If you receive a message stating that the port is online and can be reached, then you have

set it up correctly.

To connect to your DVR from the Internet, you will need to put the Internet IP address shown

after “Your Internet Address:” message into your Internet Explorer browser or access pro-

gram window.

PICTURE 18

PART 4: SETTING UP DMZ IN ROUTER 2

NOTE! You will only need to proceed with this section if you detected a

second router in Section 2.

NOTE! If you do not have a DMZ setting in the router, check to see if there

is a Bridge setting. If so, then use the Bridge setting instead of DMZ.

STEP 1. Login into Router 1 by putting

the IP of Router 1 into the Internet

Explorer browser, as in the example

shown in Picture 19 where the IP

address of Router 1 is 192.168.0.1

STEP 2. Find the status page on the

router settings that shows the WAN/

Internet IP address and write it down

this WAN IP address.

STEP 3. Log into the Router 2 by putting

the IP of Router 2 into the Internet

Explorer browser, as in example

shown in Picture 19 where the IP

address of Router 2 is 192.168.1.1

STEP 4. Find the DMZ page in the router

settings.

STEP 5. Enter the WAN IP for Router 1

into the DMZ page and enable DMZ.

PICTURE 19

STEP 6. Save your changes.

You have forwarded the ports on the router to which the DVR is connected, to the IP address

of the DVR, and set the primary router to pass the connection to this router.

NOTE! The default value is 80. If port 80 is already occupied by another device

on the network, then another port will need to be selected. Choose another

number in the same range; 81-89. In this case, you will have to add the port to

the IP address when entering it into the Internet Explorer window. For example,

if the port is now 82, then you will need to enter http://192.168.0.25:82

IMPORTANT! Do not use 255 or higher to complete your IP address as these

addresses are reserved for other devices and components.

1 2 3 4 5 6 7 8 9 10 11 12 13

Pas de commentaire

Q-See QSDT16PCRP Guide de l'utilisateur Page 6